Seals and Gaskets

Rebuilding your VW engine or just want to have some spare gaskets for future service, this is the kit you want to have around. These kits include all the gaskets...

Choose from stock style Cork/Rubber or high quality reusable neoprene. Sold in pairs.

This heavy duty green sand seal is only for engine cases that have been machined for a sand seal.

EMPI's High Quality Silicone Flywheel Seal provides outstanding sealing qualities in the most severe conditions. Resistant to failure due to extreme temperature.

EMPI's High Quality Silicone Flywheel Seal provides outstanding sealing qualities in the most severe conditions. Resistant to failure due to extreme temperature.

These high quality flywheel o-ring seals are a must for all Upright type 1 based motors. fits 66-79 bug and Ghia, 64-71 Bus and 64-73 Type 3 as well. 

EMPI's High Quality Silicone Flywheel Seal provides outstanding sealing qualities in the most severe conditions. Resistant to failure due to extreme temperature.

Oil Pump Gaskets for both oil pump body and Oil pump cover. Fits Type 1 67-79, Ghia 67-74, Type 2 67-71 and Type 3 67-73 All Gaskets are for 8mm...

Polyurethane 3/16" thick gasket to resist vibration, fits between carbs and manifold. Comes in Black. Sold in pairs

Ever get tired of cutting out intake gaskets...? Well, I did. Using a high quality .063 thick material, this gasket is stamped out with precision fit to eliminate any slop on the...

Extend the life of your engine by replacing this screen with each and every oil change. Comes complete with gaskets and sealing washers.

2 Complete oil change kits include gaskets and sealing washers.

This goes under the Alternator or Generator stand to defect oil from leaving the case.

Gasket for alternator and generator stand.

Sealing washer for oil filler to Gen/Alt pedestal. Sold each! Fits Type 1 61-74, Type 2 61-71, Type 3 64-73

This kit includes all the gaskets and seals required to rebuild your transaxle.

Transmission side cover gasket for Type 1 56-68, Ghia 56-68, Type 2 50-67, and Type 3 66-68. Sold Each.

Replace that worn out or leaking distributor shaft o-ring with this high quality one.

Covers heat riser flanges when intake heat riser is not used. A must then installing most dual carb kits. Available in Chrome or raw. Includes gaskets.

High quality replacement seals for use with stock oil cooler or with bypass adapter.

Replacement intake manifold gaskets for Empi  L5 Cylinder Heads. Sold in Pairs.

Replacement intake manifold gaskets for Empi L6 Cylinder Heads. Sold in Pairs.

Replacement intake manifold gaskets for Empi L7 Cylinder Heads. Sold in Pairs.

Replacement intake manifold gaskets for Empi D7000 Cylinder Heads. Sold in Pairs.